Connect to the GPS logger with LNS profile via Bluetooth and relay location information to your smartphone as MockLocation. how to use. By using this app, smartphone apps that use location information will no longer have built-in GPS, but instead will operate using the location information from the GPS logger. The built-in GPS acquires location information once per second, whereas the GPS logger can accurately acquire position information 5 to 20 times per second. Used in applications that analyze driving such as motor sports. The app runs as a service, so you can start the service from the app screen and it will continue to run even if you close the app screen (stopping the service is done from the app screen). To use it, you need to enable "Developer options" in your smartphone's settings and register MLS with "Select temporary current location app." Additionally, Bluetooth connection must be enabled and location permissions must be granted. Some apps, such as games that use location information, may not work with pseudo location information. *Bluetooth Smart (BT4.0) LNS(Location and Navigation Service) *Operation has been confirmed with GL-770, GL-770M (Transystem GPS logger), DigSpiceⅢ, and DigSpiceⅣ. Other GPS loggers are unconfirmed. ①Selection of GPS logger Launch the app and tap the to display a list of nearby Bluetooth devices. Select the GPS logger to connect from the list. If you pair, advertisement packets will no longer be output and you will no longer be able to search for Bluetooth devices, so if you wish to search, please cancel pairing. Also, depending on the timing, advertisement packets may not arrive, so please repeat the search. ②Connect to GPS logger Tap a GPS logger from the list to perform the connection process. After a while, if the connection with the GPS logger is completed and location information is obtained, speed, location information (latitude, longitude, altitude), and direction will be displayed in the center of the screen. It may take 2-3 minutes for the GPS logger to receive the GPS signal. If you connect to a device that is not a GPS logger, the message "Unable to connect" will be displayed. Tap the disconnect icon to disconnect. Even if you select a GPS logger, you may not be able to connect. Tap the disconnect icon to reconnect. The device selected and connected from the list is memorized. From next time onwards, you can connect directly by tapping the connection button. ③Disconnecting the GPS logger Tap the disconnect icon. ④System settings (optional) UNIT (GPS logger speed unit: km/h, m/s, knots) RESERVED_FOR_FUTURE (specify 1 if using digispice)

Relays GPS LOC to SmartPhone

Monetized Ad Creatives shown by Relays GPS LOC to SmartPhone